History of SLU/SLP/SLI & SLW in CIL The provision of upgradation to the next higher grade/category in respect of non-executive employees who remained in the same grade/category for more than 10 years was first introduced in the operation period of NCWA-IV and was brought in effect from 01-07-1989 which continued progressively on 01-07-1990, 01-07-1991 and so on. The said provision was made effective vide Implementation Instruction No-3 of NCWA-IV. In the subsequent NCWA as well, the above provision was continued to be in operation vide clause-2.11.0 of NCWA-V with effect from 01-07-1994 and thereafter on 01-07-1995. It was also agreed that if any reduction in the period of 10 years for the purpose of upgradation is mutually decided at later stage of time, the same would be effective from 01-01-1996. In the subsequent NCWA i.e. NCWA-VI (01-07-1996 to 30-06-2000), the period of 10 years was reduced to 7/8 years in UG/Surface respectively and the same was termed as SLU (Service
1. NCWA stands for: a) National Coal Wage Arrangement b) National Coal Wage Agreement c) National Coal Washery Association d) Not known 2. Effective period of which NCWA was of 4 and ½ years: a) NCWA-III b) NCWA-IV c) NCWA-V 3. The percentage of Minimum Guaranteed Benefit in NCWA-IX is: a) 24% b) 25% c) None of them 4. The effective period of NCWA-IX is from 31-06-2011 to 01-07-2016: True False 5. In NCWA-IX, the amount of Ex-gratia payable in case of death due to injury on duty is: a) 65,000/- b) 84,600/- c) 84,500/- d) None 6. Which statutory Form under The Payment of Gratuity Act, 1972 is required for payment of gratuity to the dependent after death of an employee: a) Form-E b) Form-G c) Form-A
1. Which of the following equipments are chain mounted? a) Side Discharge Loader b) Load Haul Dunper c) Both d) None 2. Which of the following is a mass production technology for UG? a) SDL b) LHD c) PSLW (Power Support Long wall) d) None 3. In which OCP, In-pit-crushing and conveying system is used for? a) Gevra Mine b) Dipka Mine c) Piparwar d) Jagannath 4. SDL & LHD in UG are used for…………… a) Transporting b) Loading c) Cutting d) Drilling 5. What are the characteristics of imported coal? a) Low ash & moisture b) High Sulphur c) Both a) & b) d) None 6. Under New Coal Distribution Policy(NCDP), Coal is sold by CIL through……… a) Fuel Supply Agreement(FSA) b) Memorandum of Understanding(MOU) c) E-auction d) All of the above 7. Which of the following equipments are used in Long wall Mining method? a) Shearer b) Road Header c) Stage Loader Crusher d) All of the above 8.
This comment has been removed by a blog administrator.
ReplyDeleteThis comment has been removed by a blog administrator.
ReplyDelete